![]() Replace the ignition key, and use the snow blower as per usual. With the sheer bolt now properly replaced in the Cub Cadet snow blower, it’s time to reconnect the spark plug required for starting the engine. If it was, everything will work without a hitch and the blades will rotate like they normally do - minus their source of power, of course. Slide the new sheer bolt into place, make sure that it’s appropriately tightened and located, and then rotate the auger manually to ensure that the replacement was done properly. Step 3: Replace the Snow Blower’s Sheer Boltįinally, align the two parts of the drive shaft in the Cub Cadet snow blower until the sheer bolt’s location is once again revealed. A gentle tapping motion is the key to an easy removal, while avoiding damage to the snow blower’s other parts. This might take a few taps, but be sure not to get impatient. Gently hammer the tap so that it makes contact with the bolt, pushing it out of the socket and making it easy to remove from the snow blower. To eliminate this problem, grab a hammer and a tap. While most sheer bolts will be pretty easy to pull out, and some will actually remove themselves from the snow blower when they’re triggered, others will be stubbornly stuck in the socket. Step 2: Work with a Stuck Sheer Bolt, if the Need Arises Simply reach in, turn or adjust the bolt until it’s loose, and then pull the bolt out of its containing socket. Once the sheer bolt has been located, as instructed in step two of the tutorial above, it should be easily visible and just as easily removable. Step 1: Reach in and Take the Sheer Bolt Out of the Snow Blower ![]() Otherwise, here’s how to remove the bolt and install its replacement. That eliminates a step of the process, making some homeowners able to save some time during the repair. ![]() In some cases, the bolt actually removes itself from the snow blower when it’s triggered by outside debris. The repair and replacement of the sheer bolt in a Cub Cadet mower is pretty easy. Repairing and Replacing the Sheer Bolt in a Cub Cadet Snow Blower If in doubt after aligning the two parts of the drive shaft, be sure to consult the Cub Cadet’s manual for verification of the location of the bolt. This will occur when the two parts of the drive shaft are aligned, making the Cub Cadet’s sheer pin and bolt easily visible to the naked eye. Next, turn the auger on the snow blower manually until the sheer pin’s location is visible. Step 2: Locate the Pin with a Few Simple Motions That will guarantee that the snow blower will not accidentally turn on. After the key has been removed from the ignition, be sure to remove the spark plug wire. These two steps are the keys to ensuring safety, but they’re not the only guarantee that will ensure no unexpected injuries occur during the replacement process. The Cub Cadet snow blower should be turned off, and the key should be removed from the ignition. Step 1: Turn the Blower Off and Ensure Safety In order to locate and replace this bolt, follow the process below. In order to remove and replace the pin, and restore the snow blower to full functioning, a few basic steps should be followed.Ĭub Cadet snow blowers have a pretty standard configuration, making it easy to locate and repair the sheer bolt if it’s triggered during the winter season. It is the first line of defense against large objects damaging the internal parts of the snow blower. The sheer bolt is connected to a pin that acts as a sort of safety mechanism, protecting the motor and the blades in the event that something other than snow gets into the blower. One of the most common repairs on a Cub Cadet Snow Blower, is the removal and replacement of the sheer bolt.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |